Skip to content

How heavy is a pool robot once it leaves the water?

Reviewed on November 19, 2026

A pool robot can feel heavier at the edge than its spec sheet suggests. Here's what makers list, and what the manuals say about the water inside.

What you need

  • Your robot's manual, or its spec sheet from the maker's site.
  • A place to rest the robot once it's out, ideally somewhere it can drain.
  • Your filter basket or bag, which you'll check when the robot is out.

What makers list

Makers give a "robot weight" on their spec pages. It's a single number for the machine. Three models from one maker show how far apart the numbers can sit.

Listed robot weight Source
7.9 kg 1
8.42 kg 2
11.04 kg 3

That's a spread of more than three kilograms inside one maker's range. So there's no single "pool robot weight." Look up the number for your own model.

Why it feels heavier at the edge

The listed weight is for the robot as the maker describes it on the page. The pages above don't say anything about water. They give one figure, and that's all.

What you lift at the pool edge is different. Water can sit in the body and the filter, debris can sit in the basket, and you're holding all of it at arm's length over the coping. It adds up.

Makers do mention this in passing. One manual has a step for the remaining water, which you drain with the robot held upright4. A storage guide from a third maker calls it hauling a heavy, water-filled machine out of the deep end5.

None of these sources gives a "wet weight" figure, so this page won't either. If a number matters to you, because of a bad back or a long carry from the pool to the shed, don't guess from the dry figure. Lift your own robot once. Judge it then.

What changes the load

  • The filter. A full basket or bag adds to what you hold. Emptying it is one of the things a manual may ask for after a run.
  • Trapped water. It leaves the robot over time. The longer you hold it up, the lighter it gets. Drain times come up in the draining notes.
  • How you lift. Manuals say to use the handle, not the cable4. The order of steps is set out in taking it out by the handle.
Why the robot feels heavierRobot's own listed weightPlus water still insidePlus a full filterWhat you feel at the pool edge
Water and debris add to the weight you lift.

If the robot is too heavy for you

Some owners can't carry the robot comfortably, wet or dry. A wheeled cart is one answer, described in a note on wheeled carts. Don't drag the robot by its cable. And don't push on if the lift hurts. Ask someone to help.

Check the spec sheet or manual for your model before you plan around any weight. The figures above are three examples from one maker, not a rule.

Cited material

  1. Dolphin E40i product page and tech specs, Maytronics
  2. Dolphin T45 product page and tech specs, Maytronics
  3. Dolphin Active 60 product page and tech specs, Maytronics
  4. Polaris 9100 Sport owner's manual, section 4.3 Removing the cleaner from pool, Polaris (via ManualsLib)
  5. How to Store a Robotic Pool Cleaner for the Off-Season, Beatbot