Skip to content

Draining a pool robot after a run

Reviewed on November 19, 2026

Water leaves a pool robot the same way it got in: through its openings, pulled out by gravity once the robot's lifted. Your job is to give it a position where that can happen.

What you need

  • Your manual, so you know whether your model has a drain plug or valve.
  • A spot over the pool, or a deck area where a little water won't matter.
  • A few minutes. No source gives a single drain time for every robot.

What the manuals say

The Polaris manual says to drain the remaining water by keeping the cleaner in a vertical position1. That is the maker's instruction.

Inyo Pools is a retailer, not a maker. Its how-to page for a Dolphin cleaner says to rest the cleaner on its side to let the water drain out2. The two differ. Follow the manual for your own robot, not a shop's guide and not this page.

How long to drain

Here's the honest answer: the sources don't give a time. None of the sources names a number of seconds or minutes, so there's no figure here to quote. If you want a drain time, follow your own manual.

Hidden spots

Water can sit in places the drain path doesn't reach. A maker's off-season guide suggests tilting the machine to empty the pump housing and filter chamber3. It also points you to your manual, in case your model has a drain plug or valve3.

That advice is written for storage. The idea still carries over. If your manual shows a plug or valve, use it as the manual says. If it doesn't, don't pry the robot open.

How the water leavesRobot comes out of the poolHold or rest it so water runs outCheck the filter and empty itMove on to storage
Gravity does the work once the robot is out.

The filter, while you're there

Draining and filter care go together, and manuals treat them that way. One manual says to clean the filter canister after each cleaning cycle1. A second maker wants the filter rinsed the moment the robot comes out, so debris can't dry and stick to it4.

Rinse only the way your manual allows. Some models have a specific filter design that opens in a set way.

Before long storage

For storing the robot between seasons, a maker's care guide lists an empty cleaner, with no water left in it, as a first step4. That's a higher bar than a quick drain after a normal run.

Where the water goes

Let it run back into the pool, or onto a deck that can take it. Keep the cable out of the puddle, and keep walkways clear. For choices about where to put the robot next, see where to park a pool robot between runs.

Don't tip water onto a power supply or a socket. Follow the manual for your own model on where the power unit sits.

Cited material

  1. Polaris 9100 Sport owner's manual, section 4.3 Removing the cleaner from pool, Polaris (via ManualsLib)
  2. How To Operate A Maytronics Dolphin Cleaner, Inyo Pools
  3. How to Store a Robotic Pool Cleaner for the Off-Season, Beatbot
  4. How to Maintain Your Robotic Pool Cleaner, Maytronics