Skip to content

Lifting a pool robot out of the pool safely

Reviewed on November 19, 2026

Bring the robot to the wall and lift it by its handle. What comes first differs, so here's the detail.

What you need

  • Your own manual, open to the page on removing the cleaner.
  • A clear spot on the deck, dry enough to stand on.
  • Nobody swimming. Never run or handle a robot while anyone is in the pool.

Step by step

  1. Check the order in your manual. It differs by maker. Per the Polaris manual, the cleaner needs a cool down period of 15 minutes at the end of the cycle, to prevent damage to the seals. It stays in the water during that time, with the green indicator lit. Once the indicator turns off, the unit can be removed1.
  2. A retailer's guide orders it differently. Inyo Pools sells pool gear and doesn't make robots. Its guide to running a Dolphin says to turn off the power before you retrieve the robot2. The maker's manual for your robot decides the order, not this page.
  3. Bring it to the wall. Draw the robot to the pool edge with the floating cable. A gentle pull is enough1.
  4. Lift by the handle. The same manual says to always lift the cleaner using the handle1.
Taking the robot outCheck your manual for the orderWait or switch off, as it saysDraw it to the wall by the cableLift by the handleDrain it as your manual says
The order differs, so your manual decides.

Never the cable

The cable is for steering the robot to the edge. It isn't a rope. The Polaris manual says that, to prevent damage, you should never lift the cleaner out of the pool using the floating cable1. The Inyo retailer guide has a cord step too, but only to slowly pull the cleaner up to the surface. Its next step has you pull the cleaner to the edge and grab the handle, and it adds not to pull the cleaner up by its power cord2. So both sources agree that the lift itself is done by the handle, never the cord. The maker's manual should decide.

Tempted to haul it up hand over hand? Don't. Steer it to the wall, then use the handle.

Models that come to you

Some robots wait at the edge when a cycle finishes. One maker lists a pick-up mode, in which the robot waits at the edge of the pool3. That spares you a reach into deep water. It doesn't change the rest of the routine, so you'd still check what your manual says about switching off and lifting. Same rules.

After it's out

Drain it the way your manual says. The Polaris manual keeps the cleaner vertical for this, while the Inyo retailer guide rests it on its side2. The position is covered on the drain page.

Does it feel heavy? Weights differ by model, and the weight page lists a few. Set the robot down gently. Don't drop it, and don't leave the cable where someone could trip.

Check your own manual

These steps come from one maker's manual and one retailer's guide. A cordless robot, or one with a lift feature, can have different steps that this page doesn't cover. Follow the manual for your own model. If it disagrees with this page, the manual wins.

Cited material

  1. Polaris 9100 Sport owner's manual, section 4.3 Removing the cleaner from pool, Polaris (via ManualsLib)
  2. How To Operate A Maytronics Dolphin Cleaner, Inyo Pools
  3. Dolphin Active 60 product page and tech specs, Maytronics