Skip to content

Where to park a pool robot between runs

Reviewed on November 19, 2026

Check your manual's storage lines first. Makers don't all say the same thing about where a robot should wait between runs, and some advice is specific to one design.

What you need

  • Your manual's storage section.
  • A spot that's shaded and dry. A caddy, a stand or a covered box can help.
  • Room for the cable, coiled, and a place for the power supply if your maker says to keep it nearby.
  • Nobody in the pool whenever the robot is running or being moved.

In the pool

Follow your maker's manual. The Polaris manual says not to leave the cleaner in the pool on a permanent basis, and to remove it at the end of each cycle1. A retailer's how-to page (Inyo Pools, not a maker) says the cleaner can remain in the pool until you are ready to pull it out2. The manual is the one to follow.

Out of the pool

One manual says to store the cleaner out of direct sunlight1. A care guide from another maker suggests a shaded, dry area for when the robot isn't in use3.

Open sun isn't what those lines describe. More on that is on the sun and heat page.

Temperature and boxes

One maker names 5° to 45°C (41° to 113°F) as the range for storage in a protected area3.

A storage guide from another maker gives roughly 41°F to 113°F as a widely recommended range. It says an unheated shed in a cold climate falls outside that range4. The same guide says a weather-resistant deck box works for shaded parking during the season, though not for winter4.

Choosing a parking spotRead your manual's storage linesPick shade and shelterCheck the temperature rangeKeep the cable coiled and clear
Work down the list and stop at your manual.

The spots at a glance

Spot What the sources say
Left in the pool Not on a permanent basis; remove at the end of each cycle1
Direct sun One manual says store out of direct sunlight1
Shaded, dry area Suggested by one maker for when it's not in use3
Deck box Shaded parking in season, not winter4
Unheated shed, cold climate Outside the range one guide gives4

Cable and carts

Wherever it goes, coil the cable so nobody trips on it. A care guide from one maker says a loose cable can trip people3. A look at caddy carts covers carts that hold the robot and cable together.

If your manual and this page disagree, the manual wins. That goes for every spot in the table above, such as a deck box or a shaded corner, and for how long the robot may stay there. The manual is written for your exact model, and this page is only a summary of a few sources.

Cited material

  1. Polaris 9100 Sport owner's manual, section 4.3 Removing the cleaner from pool, Polaris (via ManualsLib)
  2. How To Operate A Maytronics Dolphin Cleaner, Inyo Pools
  3. How to Maintain Your Robotic Pool Cleaner, Maytronics
  4. How to Store a Robotic Pool Cleaner for the Off-Season, Beatbot