Skip to content

Keeping a pool robot out of the sun and heat

Reviewed on November 19, 2026

Yes, one maker says strong sun can harm a pool robot. Makers also say to keep it shaded when it isn't running. Here's what they write.

What you need

  • A shaded, dry spot out of the sun.
  • A cover for the robot, if your maker sells or suggests one.
  • Your manual's storage page, for the temperature limits on your model.

What makers say about sun

A care guide from one maker warns that intense sun can damage some plastic parts and seals, and can fade the colour1. It says the robot can run in warm summer months. When it's not in use, it suggests storing it in a shaded, dry area1.

Two words in that guide matter. "Some" parts. "Intense" exposure. It doesn't say that every minute in daylight does harm, and the advice is about where the robot waits, not about the hours it spends working underwater.

A manual from another maker is short and plain. It says to store the cleaner out of direct sunlight2.

Heat and cold

Sun isn't the only limit. Storage temperature has a range too, and it's not the same for every maker.

  • One maker's care guide gives a storage temperature from 5°C up to 45°C (41°F up to 113°F). It adds that the spot should be protected1.
  • Your own manual may differ, so check it for the numbers that apply to your model.

None of these sources says what a hot deck surface does to a robot. This page won't guess. What the makers do ask for is shade.

Keeping the robot out of the sunTake the robot out of the poolLet it drainMove it to shadeCover it if your maker suggests
A short routine after each run.

Covers

Storage guides also care about how the cable is kept. The same care guide lists rolling up the cable so that it has no kinks as a storage step1.

A cover helps when you can't give the robot a roof. One maker advises a caddy cover against sun, wind, humidity and dust1. Which cover fits is up to your maker. What carts do is covered in this caddy explainer.

The power supply too

Don't forget the power unit. The same maker recommends positioning the power supply in a shady place. It says the unit resists splashes but not immersion. Keep it at least 11 cm (4 in) off the ground, and at least 3.5 m (12 ft) from the pool1. Follow the manual for your own power supply. Don't treat this page as the rule for your model.

A simple routine

  1. Lift the robot out by the handle, as in the lifting steps.
  2. Let it drain.
  3. Move it to shade, or cover it.

Choosing the spot? The options are laid out in a page on where the robot waits.

Cited material

  1. How to Maintain Your Robotic Pool Cleaner, Maytronics
  2. Polaris 9100 Sport owner's manual, section 4.3 Removing the cleaner from pool, Polaris (via ManualsLib)